Edelbrock - 1410
Carburetor - Marine - 4-Barrel - 750 CFM - Square Bore - Electric Choke - Mechanical Secondary - Single Inlet - Gold Chromate - Each
Edelbrock Marine Series 750 cfm, Square-Flange, Electric Choke Carburetor (non-EGR)
The Edelbrock 1410 Marine Series 750 CFM electric choke carburetor is a precisely tuned, quality-built carburetor that can handle the harsh abuse only a marine environment can inflict. Several characteristics make the 1410 Marine Series 750 CFM electric choke carburetor an outstanding marine performer. The first one is that metering rods are utilized to transition between circuits. The carburetor is unaffected by engine backfires, which means that there are no power valves to blow out, and the rods can be changed in seconds without carburetor removal or fuel draining. Secondly, the carburetor has the unique ability to hold a tune, so once it is tuned, the carburetor stay’s tuned. What this means to you is that compared to other carburetors, the performance remains consistent and the calibration stays unchanged. The lightweight all-aluminum body features a two-piece body that is iridited and assembled with PTFE-coated shafts and pump arm for maximum protection. The simple tub-type bowls and rear-pivot floats all contribute to a carburetor thats reliable, user-friendly and is easily tunable for trouble-free operation. (CALIBRATED FOR PERFORMANCE) Designed and calibrated for optimum marine performance in small-block and big-block V8 engines with Performer RPM, RPM Air-Gap and Torker II manifolds and with Performer manifolds on large cubic-inch engines. Comes with: Metering Jets - Primary .113, Secondary .107; Metering Rods - .071 x .047; Step-Up Spring - orange (5 Hg). These carburetors feature venturi diameters of 1-7/16 for the primarys and 1-9/16 for the secondarys. Throttle blade diameters are 1-11/16 for the primarys and of 1-11/16 diameter for the secondarys.
- Complies w/U.S. Coast Guard Safety Standards
- Modified Bowl Venting For Marine Compliance
- Specially Designed Throttle Shafts For Marine Use
- Accelerator Pump Seal
- 3/8 in. Inverted Flare Fuel Inlet Fitting
- Tube In Airhorn For Fuel Pump Vent
- 5 1/8 in. Flame Arrestor Flange
- Universal Marine Throttle Lever
- Revised Secondaries For Improved Transient Performance
- Factory Set Float Levels/Adjustments Are Rarely Needed
- 2-Piece Design Means No Gaskets Below The Fuel Level
- Dependable Marine Performance/Smooth Throttle Response
