Holley EFI - 558-328
Sniper EFI Hyperspark Harness; Plug And Play;
Our HyperSpark Master Kits were designed to make upgrading your ignition on a Sniper EFI-equipped engine simple. When installed concurrently with a new Sniper EFI system, the combination creates the easiest to install EFI conversion on the market - only four flying lead connections required! This harness only requires one connection to a switched power source, battery positive, battery negative, and fuel pump power. The pre-terminated connectors and a built in 40A relay provides power to all of the components within the system. With the included Sniper EFI Main Harness you no longer need to run multiple wires to provide switched power for each individual component. This not only helps prevent wiring confusion, it will speed up your install time and clean up your engine bay. Just route the harness and pre-terminated connectors to your HyperSpark coil, distributor, and ignition box and plug them in.
- Designed For Existing Or New Sniper EFI Installations
- Complete Ignition System In A Box
- Hyperspark Ignition Box/Hyperspark Ignition Coil/Hyperspark Distributor And A Plug And Play Main Harness
- Patented Clear Installation Cap Eliminates Any Confusion While Installing The Distributor
- Hyperspark CD Ignition Box Is Seal And Powder Coated To Be Installed In The Harshest Of Locations
- External LED On Hyperspark Cd Ignition Box Helps Verify 12v Cranking RPM And Low Battery Voltage
- Integrated Ignition Coil Bracket Simplifies Mounting The Ignition Coil
- Enables Timing Control On A Sniper EFI Installation
